Some work on my KV-1
#1
Some work on my KV-1
So I finally did the magnet mod on a tank. Should have done this a long time ago. It's very easy on the KV-1 and especially important since my exhaust manifold mod makes it so I have to remove the hull to add smoke fluid.
Next thing I did was glue on my 3D printed tail light lens "cover", and install a red LED in the tail light hole (Heng Long delivers the tank with the smoke exit here).
Next thing I did was glue on my 3D printed tail light lens "cover", and install a red LED in the tail light hole (Heng Long delivers the tank with the smoke exit here).
The following users liked this post:
tankme (04-23-2024)